LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LC 500 2D Coupe >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Panels / Trim - Service Information (Coupe) (2 Of 2) >> Roof Drip Side Finish Moulding >> Removal [03/2017 - ] >> Procedure

Removal [03/2017 - ]: Procedure

  1. REMOVE ROOF DRIP SIDE FINISH MOULDING LH 

    Refer to REMOVAL [03/2017 - ] 

  2. REMOVE REAR ROOF SIDE GARNISH SUB-ASSEMBLY LH 
    1. Apply protective tape around the rear roof side garnish sub-assembly LH as shown in the illustration.
      GTY800054Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    2. Using moulding remover D, detach the claws and pin as shown in the illustration.
      GTY807610Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Moulding Remover D
      Protective Tape
    3. Detach the claws and remove the rear roof side garnish sub-assembly LH.
      GTY826651Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape

      HINT: 

      • Remove the remaining 11 No. 1 outside moulding retainers on the vehicle side.
      • Do not reuse the No. 1 outside moulding retainers.
scientia non olet · About LEMON Manuals