Removal [03/2017 - ]: Procedure

REMOVE FRONT REAR WHEEL HOUSE PLATE LH
See step 1

REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY LH

Apply protective tape around the body rocker panel moulding assembly LH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Protective Tape

Turn the steering wheel to the left to provide space for the screw to be removed.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 3 screws.

Remove the 2 screws and 5 clips.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 2 screws.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Detach the claws and remove the rocker panel moulding end cover.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedure for the other sides.

Remove the screw.

HINT:

Use the same procedure for the other sides.

Place your hand at the position shown in the illustration and while pulling toward the outside of the vehicle, detach the clips and remove the body rocker panel moulding assembly LH.

	Place Hands Here
	Remove in this Direction (1)
	Remove in this Direction (2)