Removal [03/2017 - ]: Procedure

Refer to PROCEDURE - Step 1 [03/2017 - 01/2021] , or refer to PROCEDURE - Step 1 [01/2021 - 05/2023] , or refer to DISASSEMBLY [05/2023 - ]

Refer to PROCEDURE - Step 2 [03/2017 - 01/2021] , or refer to PROCEDURE - Step 2 [01/2021 - 05/2023] , or refer to DISASSEMBLY [05/2023 - ]

1. Remove the clip.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

2. Disconnect the sliding roof drain hose.

   HINT: 

   Use the same procedure for the RH side and LH side.

1. Remove the 3 nuts and rear spoiler drain end cap LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

HINT: 

Use the same procedure described for the LH side.

HINT: 

When removing the rear spoiler No. 2 seal, if the double-sided tape is difficult to remove, heat the adhesive of the rear spoiler No. 2 seal and rear spoiler drain end cap LH using a heat light.

Standard Value

WARNING:

• Do not touch the heat light and heated parts.
• Touching the heat light may result in burns.
• Touching heated parts for a long time may result in burns.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Heated Part
*b	Heat Light

1. Remove the rear spoiler No. 2 seal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Use the same procedure described for the rear spoiler NO. 2 seal.

1. Using needle-nose pliers, disconnect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the 14 nuts.
3. Detach the claw and guides and remove the active rear wing.

1. Remove the 8 collars.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002