Inspection [03/2017 - ]: Procedure
- INSPECT NO. 4 COMBINATION SWITCH ASSEMBLY
*a Component without harness connected
(No. 4 combination switch assembly)- Check the switch.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1(ECU) - 5(E) Spoiler control switch pressed Below 1 Ω Spoiler control switch not pressed 10 kΩ or higher HINT:
If the result is not as specified, replace the No. 4 combination switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Check the switch illumination and indicator light.
- Apply battery voltage to the spoiler control switch and check that the switch illumination and indicator light illuminates.
OK
Battery Connection Specified Condition Battery positive (+) → 2(IND+)
Battery negative (-) → 4(IND-)Indicator light illuminates Battery positive (+) → 7(ILL+)
Battery negative (-) → 10(ILL-)Illumination illuminates HINT:
If the result is not as specified, replace the No. 4 combination switch assembly.
- Apply battery voltage to the spoiler control switch and check that the switch illumination and indicator light illuminates.
- Check the switch.