LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LC 500 2D Coupe >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Panels / Trim - Service Information (Coupe) (2 Of 2) >> Active Rear Wing Ecu >> Removal [05/2023 - ] >> Procedure

Removal [05/2023 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    Refer to PRECAUTION [05/2023 - ]

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [05/2023 - ]

  2. REMOVE NO. 2 DECK BOARD 

    Refer to PROCEDURE - Step 12

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 3

    WARNING:
    GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    • If the airbag deploys for any reason, it may cause a serious accident.
  4. REMOVE NO. 1 DECK BOARD 

    Refer to PROCEDURE - Step 11

  5. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH 

    Refer to PROCEDURE - Step 13

  6. REMOVE REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 16

  7. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER 

    Refer to PROCEDURE - Step 19

  8. REMOVE INNER LUGGAGE COMPARTMENT TRIM COVER LH 

    Refer to PROCEDURE - Step 20

  9. REMOVE NO. 3 DECK BOARD BRACKET 
    1. Disconnect the 3 connectors.
      GTY832931Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Remove the 3 bolts and No. 3 deck board bracket as shown in the illustration.
  10. REMOVE SPOILER CONTROL ECU ASSEMBLY 
    1. Remove the nut and spoiler control ECU assembly from the No. 3 deck board bracket as shown in the illustration.
      GTY823438Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  11. REMOVE NO. 1 COMPUTER BRACKET 
    1. Detach the claw and remove the spoiler control ECU assembly as shown in the illustration.
      GTY836484Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction