Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front bumper cover removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedures | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures are not Performed | Link |
|---|---|---|---|
|
Front television camera view adjustment | Panoramic view monitor system | Refer to CALIBRATION [05/2023 - ] |
|
Television camera view adjustment HINT: Replacement or removal and installation of 2 or more parts |
HINT:
- When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedure Link Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. Refer to INITIALIZATION [05/2023 - ] Pre-collision system Variable gear ratio steering system Refer to INITIALIZATION [03/2017 - ] - Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Air conditioning system After the engine switch is turned to ON, the servo motor standard position is recognized. -
- Learning completes when vehicle is driven
- When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
- Target Adjustment (Triangle Target):
- Target Adjustment (Flat Surface Target):
Refer to TARGET ADJUSTMENT (FLAT SURFACE TARGET) [05/2023 - ]
- Driving Adjustment:
Refer to DRIVING ADJUSTMENT [05/2023 - ]