Inspection [03/2017 - ]: Procedure
- INSPECT SEAT MEMORY SWITCH
- Measure the resistance according to the value(s) in the table below.
*a 1 Switch *b 2 Switch *c 3 Switch *d SET Switch *e Component without harness connected
(Seat Memory Switch)Standard Resistance
Tester Connection Condition Specified Condition 2 (1) - 7 (E) 1 switch pressed Below 1 Ω 1 switch not pressed 10 kΩ or higher 4 (2) - 7 (E) 2 switch pressed Below 1 Ω 2 switch not pressed 10 kΩ or higher 5 (3) - 7 (E) 3 switch pressed Below 1 Ω 3 switch not pressed 10 kΩ or higher 1 (MMRY) - 7 (E) SET switch pressed Below 1 Ω SET switch not pressed 10 kΩ or higher If the result is not as specified, replace the seat memory switch.
- Apply battery voltage to the switch connector, and check that the seat memory switch illuminates.
OK
Measurement Condition Specified Condition Battery positive (+) → 3 (ILL+)
Battery negative (-) → 6 (ILL-)Switch illuminates If the result is not as specified, replace the seat memory switch.
- Measure the resistance according to the value(s) in the table below.