Inspection [05/2023 - ]: Procedure
- INSPECT REFRESHING SEAT SWITCH
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Refreshing Seat Switch)Standard Resistance
Tester Connection Condition Specified Condition 3 (SHC) - 4 (E) Switch pressed Below 1 Ω Switch not pressed 10 kΩ or higher If the result is not as specified, replace the refreshing seat switch.
- Apply battery voltage to the switch connector, and check that the refreshing seat switch illuminates.
OK
Measurement Condition Specified Condition Battery positive (+) → 2 (ILL+)
Battery negative (-) → 5 (ILL-)Switch illuminates If the result is not as specified, replace the refreshing seat switch.
- Measure the resistance according to the value(s) in the table below.