Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat assembly LH removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED / INSTALLED / REPLACED
| Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane-keeping assist system | Refer to INITIALIZATION [03/2017 - 05/2023] |
| Pre-collision system | |||
| Parking assist monitor system | Refer to INITIALIZATION [03/2017 - 05/2023] | ||
| Steering sensor zero point calibration | Variable gear ratio steering system | Refer to INITIALIZATION [03/2017 - ] | |
|
Initialize position control ECU | Front Power Seat Control System | Refer to REGISTRATION [03/2017 - ] |
|
Zero point calibration (Occupant classification system) |
|
Refer to INITIALIZATION [03/2017 - ] |
WARNING:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- There is risk of injury.
NOTE:
for Standard Seat Type:
- If the front seat airbag assembly LH was deployed, replace the front seat airbag assembly LH, front seatback frame sub-assembly LH, separate type front seatback pad, separate type front seatback cover and front seatback sub-assembly LH with the necessary parts in accordance with the extent of the collision damage.
- Replace any other damaged parts as necessary.
for Sports Seat Type:
- If the front seat airbag assembly LH was deployed, replace the front seat airbag assembly LH, front seatback frame sub-assembly LH and front seatback pad with cover LH with the necessary parts in accordance with the extent of the collision damage.
- Replace any other damaged parts as necessary.
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.