Removal [03/2017 - 05/2023]: Procedure

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [03/2017 - 05/2023]
REMOVE NO. 2 DECK BOARD
Refer to PROCEDURE - Step 11 [03/2017 - 01/2021] , or refer to PROCEDURE - Step 12 [01/2021 - 05/2023]

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

WARNING:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Wait at least 90 seconds after disconnecting the cable from the negative(-) battery terminal to disable the SRS system.
Refer to PRECAUTION [03/2017 - 04/2020] , or refer to PRECAUTION [04/2020 - 05/2023]
If the airbag deploys for any reason, it may cause a serious accident.

NOTE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

REMOVE ROOF HEADLINING ASSEMBLY (for Front Side)
Refer to REMOVAL [03/2017 - 05/2023]

REMOVE ACTIVE NOISE CONTROL MICROPHONE (for Front Side)

for Glass Roof:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

for Carbon Roof:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (for Rear Side)
Refer to REMOVAL [03/2017 - 05/2023]

REMOVE ACTIVE NOISE CONTROL MICROPHONE (for Rear Side)

Detach the claws and remove the active noise control microphone.

REMOVE MICROPHONE WIRE (for Rear Side)

Disconnect the connector.

NOTE:

The connectors used on the microphone side and vehicle wire harness side are the same shape. Make sure they are no mixed up when connecting.

*a	Connector color: black (microphone side)