Hazard Warning Switch Circuit [03/2017 - ]: Procedure

1. Using the Techstream, read the Data List.

   Refer to DATA LIST / ACTIVE TEST [03/2017 - 04/2020] , or refer to DATA LIST / ACTIVE TEST [04/2020 - 05/2023] , or refer to DATA LIST / ACTIVE TEST [05/2023 - ]

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Hazard Flasher Switch	Hazard warning signal switch	OFF or ON	OFF: Hazard warning signal switch off ON: Hazard warning signal switch on	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   Hazard Flasher Switch

   OK

   Normal condition listed above are displayed.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [03/2017 - 05/2023]  , or refer to  PROBLEM SYMPTOMS TABLE [05/2023 - ] 

Result: 

NG 

See step  2

1. Remove the integration control and panel assembly (hazard warning signal switch).

   Refer to REMOVAL [03/2017 - 05/2023] , or refer to REMOVAL [05/2023 - ]

2. Inspect the integration control and panel assembly (hazard warning signal switch).

   Refer to INSPECTION [03/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE INTEGRATION CONTROL AND PANEL ASSEMBLY (HAZARD WARNING SIGNAL SWITCH). Refer to  REMOVAL [03/2017 - 05/2023]  , or refer to  REMOVAL [05/2023 - ] 

Result: 

OK 

See step  3

1. Disconnect the P84 integration control and panel assembly (hazard warning signal switch) connector.
2. Disconnect the P26 combination meter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   P84-6 (HAZ) - P26-2 (HZSW)	Always	Below 1 Ω
   P84-3 (GND) - Body ground	Always	Below 1 Ω
   P84-6 (HAZ) or P26-2 (HZSW) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [03/2017 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR