| Yaw Rate Sensor Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Yaw Rate Sensor" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [05/2023 - ]
- Communication stop history for "Yaw Rate Sensor" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Yaw Rate Sensor" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [05/2023 - ]
- Communication system DTCs (DTCs that start with U) that correspond to "Yaw Rate Sensor Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [05/2023 - ]
|
- Yaw rate sensor branch wire or connector
- Power source circuit of yaw rate sensor
- Yaw rate sensor ground circuit
- Yaw rate sensor
|