| Shift Control ECU Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Transmission Control" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [05/2023 - ]
- Communication stop history for "Transmission Control" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Transmission Control" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [05/2023 - ]
- Communication system DTCs (DTCs that start with U) that correspond to "Shift Control ECU Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [05/2023 - ]
|
- Shift control ECU branch wire or connector
- Power source circuit of shift control ECU
- Shift control ECU ground circuit
- Shift control ECU
|