Installation [07/2020 - 05/2023]: Procedure

1. Temporarily install the front upper No. 1 suspension arm assembly LH to the front upper No. 1 arm bracket LH with the bolt and nut.

   HINT: 

   When installing the front upper No. 1 suspension arm assembly LH, temporarily tighten the bolts at the position shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	7.25°
   *b	26.3 mm (1.04 in.)
   *c	225.6 mm (8.88 in.)

2. Fully tighten the bolt.

   Torque: 45 N.m (459 kgf/cm, 33 ft.lbf) 

1. Temporarily install the front upper No. 2 suspension arm assembly LH to the front upper No. 2 arm bracket LH with the bolt and nut.

   HINT: 

   When installing the front upper No. 2 suspension arm assembly LH, temporarily tighten the bolts at the position shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	9.15°
   *b	21 mm (0.827 in.)
   *c	209.3 mm (8.24 in.)

2. Fully tighten the bolt.

   Torque: 45 N.m (459 kgf/cm, 33 ft.lbf) 

1. Install the front upper No. 1 arm bracket LH with the 3 bolts.

   Torque: 40 N.m (408 kgf/cm, 30 ft.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the front upper No. 2 arm bracket LH with the 3 bolts.

   Torque: 40 N.m (408 kgf/cm, 30 ft.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the steering knuckle assembly LH to the front upper No. 1 suspension arm assembly LH and front upper No. 2 suspension arm assembly LH with the 2 nuts.

   Torque: 60 N.m (612 kgf/cm, 44 ft.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Install 2 new clips.
   NOTE:

   Further tighten the nut up to 60° if the holes for the clip are not aligned.

Refer to INSTALLATION [07/2020 - 05/2023]

Refer to ADJUSTMENT [07/2020 - 05/2023]

Refer to ADJUSTMENT [07/2020 - ]

Refer to CALIBRATION [07/2020 - 05/2023]