LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LC 500 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Service Information (Convertible) >> Clock >> Removal [07/2020 - 05/2023] >> Procedure

Removal [07/2020 - 05/2023]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    GTY561235Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Refer to PRECAUTION [07/2020 - 05/2023]

    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

    Refer to INITIALIZATION [07/2020 - 05/2023]

  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM 

    Refer to PROCEDURE - Step 2

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to REMOVAL [07/2020 - 05/2023]

    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
      GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    • If the airbag deploys for any reason, it may cause a serious accident.
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to PRECAUTION [07/2020 - ]

  4. REMOVE MULTI-DISPLAY 

    Refer to REMOVAL [07/2020 - 05/2023]

  5. REMOVE CLOCK ASSEMBLY 
    1. GTY827594Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
      Protective Tape

      Using a thin-bladed screwdriver, detach the claw and remove the clock assembly.

      HINT: 

      Tape the thin-bladed screwdriver tip before use.

scientia non olet · About LEMON Manuals