DTC B1321-87: Lost Communication with EMV Missing Message [07/2020 - 05/2023]: Procedure
- CHECK FOR DTC (NAVIGATION SYSTEM)
- Check if navigation system DTCs are output.
Refer to DTC CHECK / CLEAR [07/2020 - 10/2022] , or refer to DTC CHECK / CLEAR [10/2022 - 05/2023]
Body Electrical > Navigation System > Trouble Codes
Result
Result Proceed to Navigation system DTCs are not output. A Navigation system DTCs are output. B
Result:
B
GO TO NAVIGATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2020 - 05/2023]
Result:
A
See step 2
- Check if navigation system DTCs are output.
- CHECK HARNESS AND CONNECTOR (METER MIRROR SUB-ASSEMBLY POWER SOURCE)
*a Front view of wire harness connector
(to Meter Mirror Sub-assembly)- Disconnect the meter mirror sub-assembly connector.
- Measure the resistance and voltage according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition P80-4 (ES) - Body ground Always Below 1 Ω Standard Voltage
Tester Connection Condition Specified Condition P80-2 (B) - Body ground Always 11 to 14 V P80-1 (IG) - Body ground Engine switch on (IG) 11 to 14 V Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 3
- CHECK HARNESS AND CONNECTOR (METER MIRROR SUB-ASSEMBLY - RADIO RECEIVER ASSEMBLY)
*a Front view of wire harness connector
(to Meter Mirror Sub-assembly)- Disconnect the cable from the negative (-) battery terminal.
- Disconnect the meter mirror sub-assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition P80-14 (TX+) - P80-15 (TX-) Cable disconnected from negative (-) battery terminal 54 Ω to 69 Ω Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 4
- CHECK FOR DTC (METER/GAUGE SYSTEM)
- Check if meter / gauge system DTCs are output.
Refer to DTC CHECK / CLEAR [07/2020 - ]
Body Electrical > Combination Meter > Trouble Codes
Result
Result Proceed to DTC B1321 is not output. A DTC B1321 is output. B
Result:
A
REPLACE METER MIRROR SUB-ASSEMBLY. Refer to REMOVAL [07/2020 - 05/2023]
Result:
B
REPLACE RADIO RECEIVER ASSEMBLY. Refer to REMOVAL [07/2020 - 05/2023]
- Check if meter / gauge system DTCs are output.