Caution / Notice / Hint
NOTE:
- When replacing the suspension control ECU, perform registration (Refer to REGISTRATION [08/2015 - ] ).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- Do not remove the steering angle sensor from the spiral cable sub-assembly.
- When replacing the spiral cable sub-assembly, confirm that the replacement part is of the correct specification.
HINT:
If DTC C1782/82 is output at the same time as C1784/84, perform troubleshooting for C1782/82 first (Refer to DTC C1782/82: Low Battery Positive Voltage [08/2015 - 08/2019] ).