Caution / Notice / Hint

NOTE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Refer to PRECAUTION [08/2015 - ] ).
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 - 08/2022] , or refer to INITIALIZATION [08/2022 - ] ).
After replacing the center airbag sensor assembly, refer to initialization.
Refer to INITIALIZATION [08/2019 - 08/2021] , or refer to INITIALIZATION [08/2021 - 08/2022] , or refer to INITIALIZATION [08/2022 - ]

HINT:

To perform the simulation method, enter the check mode (signal check) with the Techstream (Refer to CHECK MODE PROCEDURE [08/2015 - ] ), and then wiggle each connector of the airbag system or drive the vehicle on various types of road (Refer to DIAGNOSIS SYSTEM [08/2019 - ] ).