Caution / Notice / Hint

NOTE:

If the main body ECU (multiplex network body ECU) is replaced, refer to the Registration.
Refer to REGISTRATION [08/2019 - 08/2021] , or refer to REGISTRATION [08/2021 - 08/2022] , or refer to REGISTRATION [08/2022 - ]
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

HINT:

Setting the meter illumination to maximum brightness prevents the meter illumination from dimming when the light control switch is changed to the tail or head position, or changed to the AUTO position at night. Therefore, check the meter illumination setting before proceeding to the following steps.
The automatic light control sensor sensitivity can be customized.
Refer to CUSTOMIZE PARAMETERS [08/2019 - ]