Removal [09/2022 - ]: Procedure

REMOVE OUTER MIRROR
See step 1

REMOVE OUTER MIRROR COVER ASSEMBLY

w/o Panoramic View Monitor System:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 4 screws.

Pull the outer mirror cover assembly as shown in the illustration to disengage the 2 claws.

NOTE:

As the claws may be damaged, make sure not to apply force in any direction other than shown in the illustration.

HINT:

If it is difficult to disengage the claws, disengage them using a screwdriver with its tip wrapped with protective tape.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Place Hand Here
	Pull in this Direction

Pull the outer mirror cover assembly as shown in the illustration to disengage the 2 claws.

NOTE:

As the claws may be damaged, make sure not to apply force in any direction other than shown in the illustration.

HINT:

If it is difficult to disengage the claws, disengage them using a screwdriver with its tip wrapped with protective tape.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Place Hand Here
	Pull in this Direction

Pull the outer mirror cover assembly as shown in the illustration to disengage the claw and remove the outer mirror cover assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Place Hand Here
	Remove in this Direction

NOTE:

As the claws may be damaged, make sure not to apply force in any direction other than shown in the illustration.

HINT:

If it is difficult to disengage the claws, disengage them using a screwdriver with its tip wrapped with protective tape.

Disconnect the connector to remove the outer mirror cover assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

w/ Panoramic View Monitor System:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 4 screws.

Pull the outer mirror cover assembly as shown in the illustration to disengage the 2 claws.

NOTE:

As the claws may be damaged, make sure not to apply force in any direction other than shown in the illustration.

HINT:

If it is difficult to disengage the claws, disengage them using a screwdriver with its tip wrapped with protective tape.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Place Hand Here
	Pull in this Direction

Pull the outer mirror cover assembly as shown in the illustration to disengage the 2 claws.

NOTE:

As the claws may be damaged, make sure not to apply force in any direction other than shown in the illustration.

HINT:

If it is difficult to disengage the claws, disengage them using a screwdriver with its tip wrapped with protective tape.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Place Hand Here
	Pull in this Direction

Pull the outer mirror cover assembly as shown in the illustration to disengage the claw and remove the outer mirror cover assembly.

NOTE:

As the claws may be damaged, make sure not to apply force in any direction other than shown in the illustration.

HINT:

If it is difficult to disengage the claws, disengage them using a screwdriver with its tip wrapped with protective tape.

	Place Hand Here
	Pull in this Direction

Disconnect the connector.

Disconnect the connector to remove the outer mirror cover assembly.

REMOVE SIDE TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
Refer to PROCEDURE - Step 3

REMOVE OUTER MIRROR LOWER COVER

Remove the screw and outer mirror lower cover.

REMOVE OUTER MIRROR UPPER COVER

Disengage the 2 claws and 4 guides to remove the outer mirror upper cover from the side turn signal light assembly.

REMOVE VISOR COVER ASSEMBLY
1. Remove the visor cover assembly from the outer mirror actuator assembly.