Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR HV MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Front television camera view adjustment | Panoramic View Monitor System (for HV Model) | for Initialization Refer to INITIALIZATION [06/2018 - 09/2022] for Calibration Refer to CALIBRATION [06/2018 - 09/2022] |
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR GASOLINE MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Front television camera view adjustment | Panoramic View Monitor System (for Gasoline Model) | for Initialization Refer to INITIALIZATION [06/2018 - 09/2022] for Calibration Refer to CALIBRATION [06/2018 - 09/2022] |
HINT:
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radarsensor adjustment.
Refer to ADJUSTMENT [06/2018 - 08/2020] , or refer to ADJUSTMENT [08/2020 - 08/2021]