Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU [06/2018 - 09/2022]: Procedure

1. Disconnect the G1 radio receiver assembly connector.
2. Disconnect the G14 navigation ECU connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G1-7 (SUP) - G14-21 (SUP)	Always	Below 1 Ω
   G1-7 (SUP) or G14-21 (SUP) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [06/2018 - 10/2019]  , or refer to  PROBLEM SYMPTOMS TABLE [10/2019 - 08/2020]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2020 - 08/2021]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2021 - 09/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR