Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter [06/2018 - 09/2022]: Procedure

1. Disconnect the G6 radio receiver assembly connector.
2. Disconnect the G8 No. 1 stereo jack adapter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G6-14 (ADPG) - G8-2 (ADPG)	Always	Below 1 Ω
   G6-10 (AGND) - G8-7 (AGND)	Always	Below 1 Ω
   G6-12 (VAR+) - G8-6 (VAR+)	Always	Below 1 Ω
   G6-11 (VAL+) - G8-1 (VAL+)	Always	Below 1 Ω
   G6-13 (VA-) - G8-5 (VA-)	Always	Below 1 Ω
   G6-14 (ADPG) or G8-2 (ADPG) - Body ground	Always	10 kΩ or higher
   G6-10 (AGND) or G8-7 (AGND) - Body ground	Always	10 kΩ or higher
   G6-12 (VAR+) or G8-6 (VAR+) - Body ground	Always	10 kΩ or higher
   G6-11 (VAL+) or G8-1 (VAL+) - Body ground	Always	10 kΩ or higher
   G6-13 (VA-) or G8-5 (VA-) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [06/2018 - 10/2019]  , or refer to  PROBLEM SYMPTOMS TABLE [10/2019 - 08/2020]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2020 - 08/2021]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2021 - 09/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR