Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier [06/2018 - 09/2022]: Procedure
- INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY
- Measure the voltage according to the value(s) in the table below.
*a Component with harness connected
(Stereo Component Amplifier Assembly)Standard Voltage
Tester Connection Condition Specified Condition G9-1 (MUTE) - Body ground Engine switch on (ACC)
Audio system playing
→ Audio system changing modes2.0 V or higher
→ Below 1 VResult
Proceed to OK NG
Result:
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [06/2018 - 10/2019] , or refer to PROBLEM SYMPTOMS TABLE [10/2019 - 08/2020] , or refer to PROBLEM SYMPTOMS TABLE [08/2020 - 08/2021] , or refer to PROBLEM SYMPTOMS TABLE [08/2021 - 09/2022]
Result:
NG
See step 2
- Measure the voltage according to the value(s) in the table below.
- CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
- Disconnect the G6 radio receiver assembly connector.
- Disconnect the G9 stereo component amplifier assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G6-25 (MUT1) - G9-1 (MUTE) Always Below 1 Ω G6-25 (MUT1) or G9-1 (MUTE) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 3
- INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL)
- Reconnect the G9 stereo component amplifier assembly connector.
- Measure the voltage according to the value(s) in the table below.
*a Front view of wire harness connector
(to Radio Receiver Assembly)Standard Voltage
Tester Connection Condition Specified Condition G6-25 (MUT1) - Body ground Engine switch on (ACC)
Audio system playing2.0 V or higher Result
Proceed to OK NG
Result:
OK
REPLACE RADIO RECEIVER ASSEMBLY. Refer to REMOVAL [06/2018 - 08/2020] , or refer to REMOVAL [08/2020 - 09/2022]
Result:
NG
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY. Refer to REMOVAL [06/2018 - 09/2022]