Inspection [06/2018 - ]: Procedure
- INSPECT REAR SPEAKER ASSEMBLY (for 10 Speakers)
- With the speaker installed, check that there is no looseness or other abnormalities.
- Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.
- Measure the resistance of the speaker.
*a Component without harness connected
(Rear Speaker Assembly)Standard Resistance
Tester Connection Condition Specified Condition 1 (-) - 2 (+) Always 3.2 to 4.8 Ω If the result is not as specified, replace the speaker.
- INSPECT REAR SPEAKER ASSEMBLY (for 17 Speakers)
- With the speaker installed, check that there is no looseness or other abnormalities.
- Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.
- When there is a possibility that either the right or left speaker is malfunctioning, interchange the speakers and perform an inspection. If the malfunction disappears after interchanging the speakers, replace the malfunctioning speaker.
HINT:
Connect all connectors to the speakers when performing an inspection. If the result is not as specified, replace the speaker.