Inspection [06/2018 - ]: Procedure
- INSPECT REAR DOOR ILLUMINATION LIGHT LH (REAR DOOR OUTSIDE HANDLE ASSEMBLY LH)
*a Component without harness connected
(Rear Door Illumination Light LH (Rear Door Outside Handle Assembly LH))- Connect 4 dry-cell batteries (1.5 V) in series.NOTE:
Do not use rechargeable batteries as they may not output a voltage of 1.5 V.
- Apply 6.0 V battery voltage to the rear door illumination light LH (rear door outside handle assembly LH) and check that the light illuminates.
OK
Measurement Condition Specified Condition Positive (+) lead from the batteries → Terminal 1 (OLP)
Negative (-) lead from the batteries → Terminal 3 (GND)Illumination light illuminates If the result is not as specified, replace the rear door illumination light LH (rear door outside handle assembly LH).
- Connect 4 dry-cell batteries (1.5 V) in series.
- INSPECT REAR DOOR ILLUMINATION LIGHT RH (REAR DOOR OUTSIDE HANDLE ASSEMBLY RH)
*a Component without harness connected
(Rear Door Illumination Light RH (Rear Door Outside Handle Assembly RH))- Connect 4 dry-cell batteries (1.5 V) in series.NOTE:
Do not use rechargeable batteries as they may not output a voltage of 1.5 V.
- Apply 6.0 V battery voltage to the rear door illumination light RH (rear door outside handle assembly RH) and check that the light illuminates.
OK
Measurement Condition Specified Condition Positive (+) lead from the batteries → Terminal 1 (OLP)
Negative (-) lead from the batteries → Terminal 3 (GND)Illumination light illuminates If the result is not as specified, replace the rear door illumination light RH (rear door outside handle assembly RH).
- Connect 4 dry-cell batteries (1.5 V) in series.