LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> ES 350 Luxury >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting System (Ext) - Service Information >> ILLUMINATION LIGHT ASSEMBLY (for Front Door) >> Removal [06/2018 - 08/2020] >> Procedure

Removal [06/2018 - 08/2020]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch (for Gasoline Model) or power switch (for HV Model) off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    for 2GR-FKS:

    Refer to PROCEDURE - Step 1

    for A25A-FXS:

    Refer to PROCEDURE - Step 1

  3. REMOVE NO. 2 DOOR TRIM PAD 

    Refer to PROCEDURE - Step 5

  4. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side) 

    Refer to PROCEDURE - Step 6

  5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side) 

    Refer to PROCEDURE - Step 7

  6. REMOVE COURTESY LIGHT ASSEMBLY 

    Refer to PROCEDURE - Step 1

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 9

  8. REMOVE FRONT DOOR SERVICE HOLE COVER 

    Refer to PROCEDURE - Step 23

  9. REMOVE FRONT DOOR ILLUMINATION LIGHT (FRONT DOOR OUTSIDE HANDLE ASSEMBLY) 

    Refer to PROCEDURE - Step 32