Inspection [06/2018 - ]: Procedure
- INSPECT FRONT DOOR ILLUMINATION LIGHT LH (FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH)
*a Component without harness connected
(Front Door Illumination Light LH (Front Door Outside Handle Assembly LH))- Connect 4 dry-cell batteries (1.5 V) in series.NOTE:
Do not use rechargeable batteries as they may not output a voltage of 1.5 V.
- Apply 6.0 V battery voltage to the front door illumination light LH (front door outside handle assembly LH) and check that the light illuminates.
OK
Measurement Condition Specified Condition Positive (+) lead from the batteries → Terminal 1 (OLP)
Negative (-) lead from the batteries → Terminal 3 (GND)Illumination light illuminates If the result is not as specified, replace the front door illumination light LH (front door outside handle assembly LH).
- Connect 4 dry-cell batteries (1.5 V) in series.
- INSPECT FRONT DOOR ILLUMINATION LIGHT RH (FRONT DOOR OUTSIDE HANDLE ASSEMBLY RH)
*a Component without harness connected
(Front Door Illumination Light RH (Front Door Outside Handle Assembly RH))- Connect 4 dry-cell batteries (1.5 V) in series.NOTE:
Do not use rechargeable batteries as they may not output a voltage of 1.5 V.
- Apply 6.0 V battery voltage to the front door illumination light RH (front door outside handle assembly RH) and check that the light illuminates.
OK
Measurement Condition Specified Condition Positive (+) lead from the batteries → Terminal 1 (OLP)
Negative (-) lead from the batteries → Terminal 3 (GND)Illumination light illuminates If the result is not as specified, replace the front door illumination light RH (front door outside handle assembly RH).
- Connect 4 dry-cell batteries (1.5 V) in series.