Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR HV MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front bumper assembly | Front television camera view adjustment | Panoramic View Monitor System | Refer to CALIBRATION [09/2022 - ] |
Replacement or removal and installation of 2 or more parts:
|
Television camera view adjustment | ||
| Headlight ECU sub-assembly LH |
|
Lighting system (for HV Model) | Refer to INITIALIZATION [08/2021 - ] |
*1: for LED type turn signal light
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR GASOLINE MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front bumper assembly | Front television camera view adjustment | Panoramic View Monitor System | Refer to CALIBRATION [09/2022 - ] |
Replacement or removal and installation of 2 or more parts:
|
Television camera view adjustment | ||
| Headlight ECU sub-assembly LH |
|
Lighting System (for Gasoline Model) | Refer to INITIALIZATION [08/2021 - ] |
*1: for LED type turn signal light
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.