Caution / Notice / Hint
NOTE:
- If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.*1
Refer to INITIALIZATION [06/2018 - 08/2020] , or refer to INITIALIZATION [08/2020 - 08/2021]
- If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information the headlight ECU sub-assembly LH.*2
Refer to INITIALIZATION [06/2018 - 08/2020] , or refer to INITIALIZATION [08/2020 - 08/2021]
- If the headlight assembly LH has been replaced, it is necessary to synchronize the vehicle information the headlight ECU sub-assembly LH.*3
Refer to INITIALIZATION [06/2018 - 08/2020] , or refer to INITIALIZATION [08/2020 - 08/2021]
- Inspect the front side marker light bulb before performing the following procedure.*2
- When replacing the headlight ECU sub-assembly LH, always replace it with a new one. If a headlight ECU sub-assembly LH which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
- *1: for LED Type Turn Signal Light
- *2: for Bulb Type Turn Signal Light
- *3: for Bulb Type Turn Signal Light (for TMMK Made)