Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side turn signal light assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR HV MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Side television camera view adjustment | Panoramic View Monitor System (for HV Model) | for Initialization Refer to INITIALIZATION [06/2018 - 09/2022] for Calibration Refer to CALIBRATION [06/2018 - 09/2022] |
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR GASOLINE MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Side television camera view adjustment | Panoramic View Monitor System (for Gasoline Model) | for Initialization Refer to INITIALIZATION [06/2018 - 09/2022] for Calibration Refer to CALIBRATION [06/2018 - 09/2022] |
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.