DTC B15C5-11: Emergency Call Switch Circuit Short to Ground; DTC B15C5-13: Emergency Call Switch Circuit Open [10/2019 - ]: Procedure

1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG) and wait for 10 seconds or more.
4. Turn the Techstream on.
5. Clear the DTCs.

   Body Electrical > Telematics > Clear DTCs 

6. Check for DTCs and check that no DTCs are output.

   Body Electrical > Telematics > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ] 

Result: 

NG 

See step  2

1. Remove the map light sub-assembly (manual (SOS) switch).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Component without harness connected (Map light sub-assembly (Manual (SOS) Switch))

   Refer to REMOVAL [06/2018 - ]

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   13 (SIG1) - 9 (GND3)	Manual (SOS) switch not operated	410 to 414 Ω
   13 (SIG1) - 9 (GND3)	Manual (SOS) switch operated	81 to 83 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE MAP LIGHT SUB-ASSEMBLY (MANUAL (SOS) SWITCH). Refer to  REMOVAL [06/2018 - ] 

Result: 

OK 

See step  3

1. Disconnect the G128 DCM (telematics transceiver) connector.
2. Disconnect the P12 map light sub-assembly (manual (SOS) switch) connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G128-21 (SIG1) - P12-13 (SIG1)	Always	Below 1 Ω
   G128-3 (SIG-) - P12-9 (GND3)	Always	Below 1 Ω
   G128-21 (SIG1) or P12-13 (SIG1) - Body ground	Always	10 kΩ or higher
   G128-3 (SIG-) or P12-9 (GND3) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

1. Replace the DCM (telematics transceiver) with a new one.

   Refer to REMOVAL [10/2019 - 08/2020] , or refer to REMOVAL [08/2020 - 09/2022] , or refer to REMOVAL [09/2022 - ]

   NOTE:

   • The engine switch must be off.
   • Do not exchange the DCM (telematics transceiver) with one from another vehicle.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM DCM ACTIVATION. Refer to  DCM ACTIVATION [10/2019 - ]