DTC B15C0: GPS Antenna Connection Malfunction(short); DTC B15C1: GPS Antenna Connection Malfunction(break) [06/2018 - 09/2022]: Procedure

1. Clear the DTCs.

   Body Electrical > Navigation System > Clear DTCs 

2. Recheck for DTCs and check that no DTCs are output.

   Body Electrical > Navigation System > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ] 

Result: 

NG 

See step  2

1. Remove the antenna cord sub-assembly.

   Refer to REMOVAL [06/2018 - 08/2021] , or refer to REMOVAL [08/2021 - 09/2022]

2. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Component without harness connected (Antenna Cord Sub-assembly)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Component without harness connected (Antenna Cord Sub-assembly)

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A-3 - B-1	Always	Below 1 Ω
   A-3a - B-1a	Always	Below 1 Ω
   A-3 or B-1 - Body ground	Always	10 kΩ or higher
   A-3a or B-1a - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE ANTENNA CORD SUB-ASSEMBLY. Refer to  REMOVAL [06/2018 - 08/2021]  , or refer to  REMOVAL [08/2021 - 09/2022] 

Result: 

OK 

See step  3

1. Remove the navigation antenna assembly.

   Refer to REMOVAL [06/2018 - 08/2021] , or refer to REMOVAL [08/2021 - 09/2022]

2. Inspect the navigation antenna assembly.

   Refer to INSPECTION [06/2018 - 10/2019] , or refer to INSPECTION [10/2019 - 08/2021] , or refer to INSPECTION [08/2021 - ]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE RADIO RECEIVER ASSEMBLY. Refer to  REMOVAL [06/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 09/2022] 

Result: 

NG 

REPLACE NAVIGATION ANTENNA ASSEMBLY. Refer to  REMOVAL [06/2018 - 08/2021]  , or refer to  REMOVAL [08/2021 - 09/2022]