LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> ES 350 Luxury >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Audio / Video System (Except Hybrid) - Diagnostic Codes & Symptom Tests >> AUDIO AND VISUAL SYSTEM (for Gasoline Model) >> DTC B1575: GVIF Disconnected (from EMV/MM Integrated Device to Multi Display) [06/2018 - 08/2021] >> Procedure

DTC B1575: GVIF Disconnected (from EMV/MM Integrated Device to Multi Display) [06/2018 - 08/2021]: Procedure

  1. CHECK DTC 
    1. Clear the DTCs.

      Body Electrical > Navigation System > Clear DTCs 

    2. Turn the engine switch off.
    3. Recheck for DTCs and check that no DTCs are output.

      Body Electrical > Navigation System > Trouble Codes 

      OK

      No DTCs are output.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ] 

    Result: 

    NG 

    See step  2

  2. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY ASSEMBLY - RADIO RECEIVER ASSEMBLY) 
    1. Disconnect the G113 multi-display assembly connector.
      GTY799814Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to Radio Receiver Assembly)
      *b Front view of wire harness connector
      (to Multi-display Assembly)
    2. Disconnect the G111 radio receiver assembly connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      G111-2 (GVIF+) - G113-1 (GVIF+) Always Below 1 Ω
      G111-1 (GVIF-) - G113-2 (GVIF-) Always Below 1 Ω
      G111-3 (GND) - G113-3 (GND) Always Below 1 Ω
      G111-2 (GVIF+) or G113-1 (GVIF+) - Body ground Always 10 kΩ or higher
      G111-1 (GVIF-) or G113-2 (GVIF-) - Body ground Always 10 kΩ or higher
      G111-3 (GND) or G113-3 (GND) - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    OK 

    See step  3

  3. CHECK MULTI-DISPLAY ASSEMBLY 
    1. Replace the multi-display assembly with a new or known good one.

      Refer to REMOVAL [06/2018 - 08/2021]

    2. Clear the DTCs.

      Body Electrical > Navigation System > Clear DTCs 

    3. Turn the engine switch off.
    4. Recheck for DTCs and check that no DTCs are output.

      Body Electrical > Navigation System > Trouble Codes 

      OK

      No DTCs are output.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END (MULTI-DISPLAY ASSEMBLY IS DEFECTIVE) 

    Result: 

    NG 

    REPLACE RADIO RECEIVER ASSEMBLY. Refer to  REMOVAL [06/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 09/2022]