No. 1 Clearance Warning Buzzer Circuit [06/2018 - 09/2022]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Advanced Parking Guidance/ICS/Intuitive P/A / Active Test.
5. Check that the buzzer operates by performing the Active Test.

   Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   Buzzer	No. 1 clearance warning buzzer	Operate or Stop	Confirm that the vehicle is stopped and the engine switch is on (IG)

   Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Active Test 

   Tester Display
   Buzzer

   OK

   The No. 1 clearance warning buzzer sounds.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE CLEARANCE WARNING ECU ASSEMBLY. Refer to  REMOVAL [06/2018 - 08/2021]  , or refer to  REMOVAL [08/2021 - 09/2022] 

Result: 

NG 

See step  2

1. Disconnect the N41 clearance warning ECU assembly connector.
2. Disconnect the G65 No. 1 clearance warning buzzer connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   N41-14 (CBZ) - G65-1 (Z+)	Always	Below 1 Ω
   N41-13 (EF) - G65-2 (Z-)	Always	Below 1 Ω
   N41-14 (CBZ) or G65-1 (Z+) - Body ground	Always	10 kΩ or higher
   N41-13 (EF) or G65-2 (Z-) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Replace the No. 1 clearance warning buzzer with a new or known good one.

   Refer to REMOVAL [06/2018 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Advanced Parking Guidance/ICS/Intuitive P/A / Active Test.
5. Check that the buzzer operates by performing the Active Test.

   Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   Buzzer	No. 1 clearance warning buzzer	Operate or Stop	Confirm that the vehicle is stopped and the engine switch is on (IG)

   Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Active Test 

   Tester Display
   Buzzer

   OK

   The No. 1 clearance warning buzzer sounds.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END 

Result: 

NG 

REPLACE CLEARANCE WARNING ECU ASSEMBLY. Refer to  REMOVAL [06/2018 - 08/2021]  , or refer to  REMOVAL [08/2021 - 09/2022]