Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR HV MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Ultrasonic sensor |
|
|
Refer to CALIBRATION [09/2022 - ] |
| Front bumper assembly* | Front television camera view adjustment | Panoramic View Monitor System | Refer to CALIBRATION [09/2022 - ] |
Replacement or removal and installation of 2 or more parts:
|
Television camera view adjustment |
*: w/ Panoramic View Monitor System
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR GASOLINE MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Ultrasonic sensor |
|
|
Refer to CALIBRATION [09/2022 - ] |
| Front bumper assembly* | Front television camera view adjustment | Panoramic View Monitor System | Refer to CALIBRATION [09/2022 - ] |
Replacement or removal and installation of 2 or more parts:
|
Television camera view adjustment |
*: w/ Panoramic View Monitor System