Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR HV MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Ultrasonic sensor |
|
|
Refer to CALIBRATION [06/2018 - 08/2021] |
| Front bumper assembly* | Front television camera view adjustment | Panoramic View Monitor System | Refer to CALIBRATION [06/2018 - 09/2022] |
*: w/ Panoramic View Monitor System
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR GASOLINE MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Ultrasonic sensor |
|
|
Refer to CALIBRATION [06/2018 - 08/2021] |
| Front bumper assembly* | Front television camera view adjustment | Panoramic View Monitor System | Refer to CALIBRATION [06/2018 - 09/2022] |
*: w/ Panoramic View Monitor System