Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during electrical key antenna removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR HV MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative auxiliary battery terminal*1 | Perform steering sensor zero point calibration | Lane Control System | Refer to INITIALIZATION [06/2018 - 08/2021] |
| Pre-collision System | |||
| Parking Support Brake System*2 | |||
| Lighting System | |||
| Memorize steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [06/2018 - 09/2022] | |
| Panoramic View Monitor System | Refer to INITIALIZATION [06/2018 - 09/2022] | ||
| Initialize power trunk lid system | Power Trunk Lid System | Refer to INITIALIZATION [06/2018 - ] |
*1: w/ Hands Free Power Trunk Lid*2: When performing learning using the Techstream.
NOTE:
- After the power switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal. (for Audio and Visual System)
- After the power switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal. (for Navigation System)
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR GASOLINE MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal*1 | Perform steering sensor zero point calibration | Lane Control System | Refer to INITIALIZATION [06/2018 - 08/2021] |
| Pre-collision System | |||
| Parking Support Brake System*2 | |||
| Lighting System | |||
| Memorize steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [06/2018 - 09/2022] | |
| Panoramic View Monitor System | Refer to CALIBRATION [06/2018 - 09/2022] | ||
| Initialize power trunk lid system | Power Trunk Lid System | Refer to INITIALIZATION [06/2018 - ] |
*1: w/ Hands Free Power Trunk Lid*2: When performing learning using the Techstream.
NOTE:
- After the engine switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Audio and Visual System)
- After the engine switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System)