LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> ES 350 F Sport >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Electric Parking Brake System (Except Hybrid) - Diagnostic Codes & Symptom Tests >> ELECTRIC PARKING BRAKE SYSTEM (for Gasoline Model) >> DTC C060B-12: Left Electric Parking Brake Actuator Control Circuit Short to Battery [06/2018 - ] >> Procedure

DTC C060B-12: Left Electric Parking Brake Actuator Control Circuit Short to Battery [06/2018 - ]: Procedure

  1. CHECK FOR SHORT TO +B 
    1. Turn the engine switch off.
    2. Make sure the No. 2 parking brake wire assembly is securely installed.
    3. Disconnect the b3 parking brake actuator assembly LH connector.
    4. Measure the voltage according to the value(s) in the table below.
      GTY833694Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of No. 2 Parking Brake Wire Assembly
      (to Parking Brake Actuator Assembly LH)

      Standard Voltage

      Tester Connection Condition Specified Condition
      b3-2 (LE+) - b3-1 (LE-) Electric parking brake not operating Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE PARKING BRAKE ACTUATOR ASSEMBLY LH. Refer to  REMOVAL [06/2018 - ] 

    Result: 

    NG 

    See step  2

  2. CHECK FOR SHORT TO +B 
    1. Disconnect the bN4 No. 2 parking brake wire assembly connector.
    2. Measure the voltage according to the value(s) in the table below.
      GTY811130Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to No. 2 Parking Brake Wire Assembly)

      Standard Voltage

      Tester Connection Condition Specified Condition
      bN4-2 - bN4-1 Electric parking brake not operating Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE NO. 2 PARKING BRAKE WIRE ASSEMBLY 

    Result: 

    NG 

    See step  3

  3. CHECK FOR SHORT TO +B 
    1. Disconnect the bN4 No. 2 parking brake wire assembly connector.
    2. Disconnect the A40 skid control ECU (brake actuator assembly) connector.
    3. Measure the voltage according to the value(s) in the table below.
      GTY809145Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector *b (to Skid Control ECU (Brake Actuator Assembly))
      *c (to No. 2 Parking Brake Wire Assembly) - -

      Standard Voltage

      Tester Connection Condition Specified Condition
      bN4-2 or A40-13 (MRL+) - Body ground Always Below 1 V
      bN4-1 or A40-12 (MRL-) - Body ground Always Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY). Refer to  REMOVAL [06/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 - 09/2022]  , or refer to  REMOVAL [09/2022 - ] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR