| Active Noise Control ECU Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Active Noise Control" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [08/2020 - ]
- Communication stop history for "Active Noise Control" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Active Noise Control" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [08/2020 - ]
- Communication system DTCs (DTCs that start with U) that correspond to "Active Noise Control ECU Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [09/2022 - ]
|
- Stereo component equalizer assembly branch line or connector
- Power source circuit of stereo component equalizer assembly
- Stereo component equalizer assembly ground circuit
- Stereo component equalizer assembly
|