Slip Indicator Light does not Come ON [06/2018 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Enter the following menus: Body Electrical / Combination Meter / Active Test.
4. Perform the Active Test of the combination meter assembly using the Techstream.

   Refer to DATA LIST / ACTIVE TEST [06/2018 - 08/2020] , or refer to DATA LIST / ACTIVE TEST [08/2020 - 08/2021] , or refer to DATA LIST / ACTIVE TEST [08/2021 - ]

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Slip Warning

5. Check the combination meter assembly.

   OK

   The slip indicator light turns on or off in accordance with Techstream operation.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE BRAKE ACTUATOR ASSEMBLY. Refer to  REMOVAL [06/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 - 09/2022]  , or refer to  REMOVAL [09/2022 - ] 

Result: 

NG 

INSPECT METER / GAUGE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]