ABS Operates Before Necessary When Braking [06/2018 - 08/2020]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Enter the following menus: Chassis / Brake/EPB / Utility / Signal Check.
4. Using the Techstream, perform a Dealer Mode (Signal Check) inspection sensor check and check that speed sensor Dealer Mode (Signal Check) inspection items change from incomplete to complete.

   Refer to TEST MODE PROCEDURE [06/2018 - 08/2020]

   Chassis > Brake/EPB > Utility 

   Tester Display
   Signal Check

   OK

   Speed sensor Dealer Mode (Signal Check) inspection items change from incomplete to complete.

   Result

   Result	Proceed to
   OK (for Front)	A
   OK (for Rear)	B
   NG	C

   NOTE:

   • When cleaning the front speed sensor, make sure to clean the installation hole before installation.
   • Do not use parts cleaner when cleaning the front speed sensor rotor.

   HINT: 

   The rear speed sensor and rear speed sensor rotor are incorporated into the rear axle hub and bearing assembly.

   If the rear speed sensor and rear speed sensor rotor need to be replaced, replace the rear axle hub and bearing assembly.

Result: 

A 

CLEAN FRONT SPEED SENSOR AND FRONT SPEED SENSOR ROTOR 

Result: 

B 

REPLACE REAR AXLE HUB AND BEARING ASSEMBLY. Refer to  REMOVAL [06/2018 - 08/2021] 

Result: 

C 

INSPECT AND REPAIR MALFUNCTIONING SPEED SENSOR CIRCUIT