Installation [08/2020 - ]: Procedure

1. Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.
   NOTE:

   Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Stopper
   *b	Cutout

   HINT: 

   The cutout of the rear stabilizer bushing can be positioned either up or down.

1. Install the 2 rear No. 1 stabilizer bar brackets to the 2 rear stabilizer bushings.
   NOTE:

   • Ensure that the identification mark faces the right side of the vehicle.
   • Be sure to install the rear No. 1 stabilizer bar brackets so that each arrow mark faces the upper side of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Arrow Mark
   *b	Identification Mark
   	Upper Side of the Vehicle

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Install the 2 rear lower stabilizer brackets to the rear stabilizer bushing.

1. Install the rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets, 2 rear stabilizer bushings and 2 rear lower stabilizer brackets to the rear suspension member sub-assembly with the 4 bolts.

   Torque: 78 N.m (795 kgf/cm, 58 ft.lbf) 

   NOTE:

   • Ensure that the identification mark faces the right side of the vehicle.
   • Temporarily tighten the bolt (A) and then fully tighten the 2 bolts in the order of (B) and (A).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Mark

Refer to PROCEDURE - Step 4 [08/2020 - 09/2022] , or refer to PROCEDURE - Step 4 [09/2022 - ]

1. Using a ball joint lock nut wrench, install the rear stabilizer link assembly LH with the nut (A).

   Torque: 95 N.m (969 kgf/cm, 70 ft.lbf) 

   HINT: 

   • If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.
   • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

     Refer to PRECAUTION [06/2018 - ]

   • When using a ball joint lock nut wrench (fulcrum length of 149 mm (5.87 in.)) + torque wrench (fulcrum length of 400 mm (1.31 ft.)):

     69 N.m (704 kgf/cm, 51 ft.lbf)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Torque Wrench Fulcrum Length

2. Install the rear stabilizer link assembly LH with the bolt and nut (B).

   Torque: 81 N.m (826 kgf/cm, 60 ft.lbf) 

   NOTE:

   • Because the nut (B) has its own stopper, do not turn the nut (B). Tighten the bolt with the nut (B) secured.
   • Insert the bolt with the threaded end facing the front of the vehicle.
3. Install the cap to the rear stabilizer link assembly LH.

HINT: 

Perform the same procedure as for the LH side.

Refer to INSTALLATION [08/2020 - ]

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 9