Confirmation Driving Pattern

HINT: 

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Refer to UTILITY [06/2018 - ]

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG) and turn the Techstream on.
3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
4. Turn the power switch off and wait for 2 minutes or more.
5. Turn the power switch on (IG) and turn the Techstream on.
6. Turn the power switch on (READY) with shift lever in P and cause the "Hybrid Battery SOC" to decrease. Check that the engine is started to charge the HV battery, and the value of Data List item "Hybrid Battery SOC" increases and then remains within an appropriate range.
7. Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
8. Check the DTC judgment result.

   HINT: 

   • If the judgment result shows NORMAL, the system is normal.
   • If the judgment result shows ABNORMAL, the system has a malfunction.
   • If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.