Engine Oil Pressure Switch Circuit [06/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2024 Lexus ES 350, 2024 Lexus ES 250, 2023 Lexus ES 350, 2023 Lexus ES 250, and 2022 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
- Inspect the engine oil pressure switch assembly.
Refer to INSPECTION [06/2018 - ]
Result
Proceed to OK NG
Result:
NG
REPLACE ENGINE OIL PRESSURE SWITCH ASSEMBLY. Refer to REMOVAL [06/2018 - ]
Result:
OK
See step 2
- Inspect the engine oil pressure switch assembly.
- CHECK HARNESS AND CONNECTOR (ENGINE OIL PRESSURE SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)
- Disconnect the G17 combination meter assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C23-1 - G17-9 (S) Always Below 1 Ω C23-1 or G17-9 (S) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL [06/2018 - 08/2021] , or refer to REMOVAL [08/2021 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR