Engine Oil Level Sensor Circuit [08/2020 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2024 Lexus ES 350, 2024 Lexus ES 250, 2023 Lexus ES 350, 2023 Lexus ES 250, and 2022 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT ENGINE OIL LEVEL SENSOR
- Remove the engine oil level sensor.
for 2GR-FKS: Refer to REMOVAL [10/2019 - 08/2021] , or refer to REMOVAL [08/2021 - 09/2022] , or refer to REMOVAL [09/2022 - ]
for A25A-FKS: Refer to REMOVAL [08/2020 - ]
- Inspect the engine oil level sensor.
for 2GR-FKS: Refer to INSPECTION [06/2018 - ]
for A25A-FKS: Refer to INSPECTION [08/2020 - ]
Result
Proceed to OK NG
Result:
NG
REPLACE ENGINE OIL LEVEL SENSOR
for 2GR-FKS: Refer to REMOVAL [10/2019 - 08/2021] , or refer to REMOVAL [08/2021 - 09/2022] , or refer to REMOVAL [09/2022 - ]
for A25A-FKS: Refer to REMOVAL [08/2020 - ]
Result:
OK
See step 2
- Remove the engine oil level sensor.
- CHECK HARNESS AND CONNECTOR (ENGINE OIL LEVEL SENSOR - COMBINATION METER ASSEMBLY)
- Disconnect the G17 combination meter assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C22-1 - G17-15 (OILW) Always Below 1 Ω C22-1 or G17-15 (OILW) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL [06/2018 - 08/2021] , or refer to REMOVAL [08/2021 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR