LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> ES 300h Luxury >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Control System (2GR-FKS) - Service Information) >> ACTIVE CONTROL ENGINE MOUNT (for Rear Side) >> Installation [06/2018 - ] >> Procedure

Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL REAR ENGINE MOUNTING INSULATOR 
    1. Engage the clamp and install the vacuum hose to the rear engine mounting insulator.
    2. Install the wire harness clamp bracket to the rear engine mounting insulator with the bolt.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

    3. Align the hole of the rear engine mounting insulator with the protrusion of the rear engine mounting bracket, slide the rear engine mounting insulator onto the rear engine mounting bracket to align the holes and install the rear engine mounting insulator with the bolt.

      Torque: 72 N.m (734 kgf/cm, 53 ft.lbf) 

      GTY758214Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Rear Engine Mounting Bracket
      *2 Rear Engine Mounting Insulator
      *a Protrusion
      *b Hole
  2. INSTALL FRONT FRAME ASSEMBLY 

    Refer to INSTALLATION [06/2018 - ]

scientia non olet · About LEMON Manuals