Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR HV MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Front television camera view adjustment | Panoramic View Monitor System (for HV Model) | Refer to INITIALIZATION [06/2018 - 09/2022] for Initialization Refer to CALIBRATION [06/2018 - 09/2022] for Calibration |
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR GASOLINE MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Front television camera view adjustment | Panoramic View Monitor System (for Gasoline Model) | Refer to INITIALIZATION [06/2018 - 09/2022] for Initialization Refer to CALIBRATION [06/2018 - 09/2022] for Calibration |
HINT:
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radarsensor adjustment.
TARGET ADJUSTMENT(TRIANGLE TARGET):
Refer to TARGET ADJUSTMENT(TRIANGLE TARGET) [08/2021 - ]
TARGET ADJUSTMENT(FLAT SURFACE TARGET):
Refer to TARGET ADJUSTMENT(FLAT SURFACE TARGET) [08/2021 - ]
DRIVING ADJUSTMENT:
Refer to DRIVING ADJUSTMENT [08/2021 - ]