Rear Sunshade does not Operate with Rear Sunshade Switch [06/2018 - ]: Procedure
- INSPECT REAR SUNSHADE SWITCH (REFRESHING SEAT SWITCH)
- Remove the rear sunshade switch (refreshing seat switch).
Refer to REMOVAL [06/2018 - ]
- Inspect the rear sunshade switch (refreshing seat switch).
Refer to INSPECTION [06/2018 - ]
Result
Proceed to OK NG
Result:
NG
REPLACE REAR SUNSHADE SWITCH (REFRESHING SEAT SWITCH). Refer to REMOVAL [06/2018 - ]
Result:
OK
See step 2
- Remove the rear sunshade switch (refreshing seat switch).
- INSPECT REAR WINDOW SHADE ASSEMBLY
- Remove the rear window shade assembly.
Refer to REMOVAL [06/2018 - 08/2021] , or refer to REMOVAL [08/2021 - 09/2022] , or refer to REMOVAL [09/2022 - ]
- Inspect the rear window shade assembly.
Refer to INSPECTION [06/2018 - ]
Result
Proceed to OK NG
Result:
NG
REPLACE REAR WINDOW SHADE ASSEMBLY. Refer to REMOVAL [06/2018 - 08/2021] , or refer to REMOVAL [08/2021 - 09/2022] , or refer to REMOVAL [09/2022 - ]
Result:
OK
See step 3
- Remove the rear window shade assembly.
- CHECK HARNESS AND CONNECTOR (REAR SUNSHADE RELAY - POWER SOURCE AND BODY GROUND)
- Measure the voltage and resistance according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition N63-8 (B) - Body ground Power switch off 11 to 14 V N63-7 (IG) - Body ground Power switch off Below 1 V N63-7 (IG) - Body ground Power switch on (IG) 11 to 14 V Standard Resistance
Tester Connection Condition Specified Condition N63-1 (E) - Body ground Always Below 1 Ω Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 4
- Measure the voltage and resistance according to the value(s) in the table below.
- CHECK HARNESS AND CONNECTOR (REAR SUNSHADE RELAY - REAR SUNSHADE SWITCH (REFRESHING SEAT SWITCH) AND BODY GROUND)
- Disconnect the N63 rear sunshade relay connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition N63-5 (RSW) - G35-5 (ECU) Always Below 1 Ω N63-5 (RSW) or G35-5 (ECU) - Body ground Always 10 kΩ or higher G35-6 (E) - Body ground Always Below 1 Ω Result
Proceed to OK NG
Result:
OK
REPLACE REAR SUNSHADE RELAY. Refer to REMOVAL [06/2018 - 08/2021] , or refer to REMOVAL [08/2021 - 09/2022] , or refer to REMOVAL [09/2022 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR