LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> ES 250 Luxury >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transmission System (UB80F) - Service Information (1 Of 2) >> Transmission Control Cable >> Removal [09/2022 - ] >> Procedure

Removal [09/2022 - ]: Procedure

  1. REMOVE BATTERY 

    Refer to REMOVAL [09/2022 - ]

  2. REMOVE ECM 

    Refer to REMOVAL [09/2022 - ]

  3. REMOVE BATTERY CLAMP SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  4. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) 

    Refer to REMOVAL [08/2020 - ]

  5. REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR 
    1. Remove the 2 nuts and front lower No. 1 floor heat insulator from the vehicle body.
      GTY958231Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY 

    Refer to REMOVAL [09/2022 - ] 

  7. REMOVE NO. 1 CONSOLE BOX DUCT 
    1. Remove the No. 1 console box duct.
      GTY784005Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip.
      GTY744811Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Clip
      *b 45° to 60°
    2. Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
      GTY762238Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 2 nuts and disconnect the transmission control cable assembly from the vehicle body.
      GTY958232Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.
      GTY958234Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals